Kent Tankless Water Heater logo
Wall-mounted gas tankless water heater with copper water lines, service valves and a white PVC vent in a home garage

Free referral line for Kent, WA

Tankless Water Heater Replacement in Kent, WA

  • Typical cost: HomeGuide puts a replacement tankless unit at $1,400 to $4,600 installed; Angi's labor table lists $600 to $1,900 for the swap itself.
  • Time: 3 to 10 hours of install labor, by HomeGuide's estimate.
  • Lifespan: DOE gives most tankless units more than 20 years.
  • Replace-or-repair line: a unit over 10 years old, or a repair above 50% of a new one.

Kent Tankless Water Heater lines you up with one licensed local plumber for the tankless unit that has given out, and the plumber quotes the job directly. Send the brand, model number and install year from the label, plus any code the display shows.

Tankless Water Heater Replacement Jobs in Kent

Replacing a tankless heater ranges from an afternoon swap to a small conversion, depending on what changes between the old unit and the new one.

Gloved hands mounting a new tankless water heater below an existing vent collar

Swapping a Tankless Unit Onto the Existing Vent and Gas Line

The simplest job keeps the same fuel, roughly the same size and the same vent route. Even so, the old vent pipe is not automatically fine for the new heater. Rinnai's manual says reused venting has to be inspected for damage and confirmed as approved for the new model, and it forbids mixing vent components from different manufacturers. So a change of brand can mean a change of vent. Ask the plumber to check the vent and the gas pipe size against the new unit's manual before quoting.

Moving Up From Non-Condensing to Condensing

Navien rates its condensing units at up to 0.96 UEF against 0.80 for non-condensing ones, which is why many replacements step up. The cooler exhaust can run in PVC or polypropylene. The new item on the quote is a condensate drain line to a floor drain or a pump, usually with a neutralizer kit that raises the condensate's pH before it reaches the drain. The venting page covers terminations and clearances.

Changing Fuel: Electric to Gas or Gas to Electric

A fuel switch turns a replacement into a bigger project. Angi's figures:

  • Electric to gas: a new gas line averages $260 to $820, and past $1,500 when the house is switching fuels.
  • Gas to electric: the panel decides it. A whole-house electric unit can mean a service upgrade; the amp figures are on the electric tankless page.

Gas needs a word with PSE about the meter first (gas line page); electric needs the panel math on the electric tankless page.

Units With a Failed Heat Exchanger

The heat exchanger is the part that heats the water, and it's the costliest repair a tankless unit gets:

  • HomeGuide: $600 to $700 for labor alone, or $1,200 to $1,300 with the part.
  • Angi: $500 to $1,300.
  • Warranty: HomeGuide says manufacturers cover labor for 1 year and parts for 5 to 12 years. ENERGY STAR requires at least 6 years on the heat exchanger for a certified gas tankless unit.

Read the warranty before you decide. Rinnai's manual excludes scale damage to the heat exchanger, so a unit that was never descaled may not be covered (the maintenance page covers flushing).

Adding Service Valves an Old Install Lacks

Older installs sometimes went in without isolation valves. Rinnai doesn't ship them in the box but strongly recommends them: they isolate the heater from the house plumbing and let the heat exchanger be flushed quickly, and they have to meet ANSI Z21.10.3. A replacement is the cheap moment to add them. The pressure relief valve also gets set right, near the hot outlet with no shutoff between it and the heater (relief valve rules).

Gloved hands turning a brass service valve under a tankless water heater with a flush hose running into a bucket

Why Kent homeowners and businesses call Kent Tankless Water Heater

  • Your details go to a single independent plumber, not a list of bidders
  • The referral is free, and booking is your call
  • Ask for gas line, vent and wiring costs as separate lines
  • Ask which Kent and L&I permits the job needs
  • Keep the down payment small and pay as work is finished

Get a free tankless water heater estimate

Free for homeowners and businesses. One local contractor contacts you.

Tankless Water Heater Lifespan and the Replace-or-Repair Call

The sources disagree on how long a tankless heater lasts:

Source Tankless life Tank life
DOE Energy Saver More than 20 years 10 to 15 years
Rinnai Up to 20 years About half as long
Angi Up to 20 years or more 8 to 12 years
HomeGuide repair guide 10 to 20 years 8 to 15 years

DOE also notes that tankless parts are easily replaced, which can stretch a unit's life well past the cost guides' figures. That's why age alone shouldn't decide it.

Both cost guides use the same two tests. HomeGuide says to consider replacement when a unit is over 10 years old or the repair would cost more than half of a new one. Angi adds the other side: under 10 years old with a minor fault, fixing it is usually worth it, and its average repair bill is $600 against $2,500 to $4,500 for a full replacement. In practice that means a 12-year-old unit with a cracked heat exchanger is a replacement, and a 5-year-old one with a bad sensor is a repair. The fault list and error codes are on the tankless repair page.

Ready to get started in Kent?

Tell us about the job and a local tankless water heater contractor will get back to you with a free estimate.

Get a free tankless water heater estimate

Free for homeowners and businesses. One local contractor contacts you.